Casting molding machine,Fully automatic casting molding machine,Green sand mold casting molding machine,Fully automatic horizontal flaskless molding machine,casting molding line factory
Home - NEWS

Introduction to the safety checklist for fully automatic molding machines

Aug,08,2023visited: 145

Introduction to the safety checklist for fully automatic molding machine:

The fully automatic molding machine is the main equipment for mechanical modeling and should be used and kept by a dedicated person. To the cylinder and guide. The shaft should be lubricated daily with oil. The molding board should be firm, and the core box screws must be tightened to prevent loosening and accidents.

1、 Equipment inspection

1. The shock cylinder should be intact, with sensitive and reliable action. A sound-absorbing pad should be installed between the shock cylinder and the anvil seat.

2. The guide rod or guide block of the shock cylinder should be complete, flexible, and reliable in operation. And there are solid and reliable limit nuts

Or limit stop.

3. The ejector pin should be able to flexibly adjust the spacing and height of the ejector pin, and have sufficient strength and stiffness under maximum load

Sex.

4. Using a return mold lifting mechanism, the rod path or bracket of the support box must be flat and able to support the sand box stably.

5. The rotation of the pressure head must be flexible, lightweight, and reliable, and a limited position blocking iron should be installed.

6. The limit device for the rotation of the pressure head should be equipped with an adjustable buffer device.

7. The positioning pins of the pressure head should be complete and reliable in function, and can reliably position the pressure head when it enters the working position.

8. Compressed air water separators, oil atomizers, etc. should be installed in the pneumatic system.

9. The pressure gauge should be sensitive, correct, reliable, and regularly calibrated.

10. The directional valve should act sensitively, correctly, and reliably.

11. The pneumatic system should have a smooth gas path, good sealing, and no blockage or leakage.


2、 Behavior check

1. When the flip table flips, the operator is not allowed to stand within the range of motion of the flip table.

2. When the fully automatic horizontal molding machine is in motion, it is not allowed to reach into the sand box.

3. If a malfunction occurs midway, the handle should be immediately pushed to the closed position.


3、 Work environment

1. The ground in the control area of the automatic molding machine should be flat and concrete ground should be selected.

2. When the automatic molding machine is installed in the pit, a flat and firm cover plate should be installed around the pit.

3. When there are sand return ports around the automatic molding machine, the sand return port should be equipped with a solid grid, and the grid gap should not be large

At 40mm.

4. The idle noise of the automatic molding machine shall not exceed 85dB (A).


end

Copyright © 2010-2023 CASTKING Casting Mechanical Equipment Co., Ltd All rights reserved. XML Sitemap