The correct method for using a fully automatic casting molding machine is as follows:

1. Before starting the fully automatic casting molding machine, the lubrication device of the molding machine should be checked for completeness, and oil should be added according to regulations. All tightening components should be checked for tightness, all operating handles should be in the zero position (empty position), the air valve action should be flexible, and there should be no air leakage in the pipeline. Then, the main air valve should be opened to release any accumulated air and water in the pipeline.

2. When using a casting molding machine, the operator should be familiar with the mechanical components, electrical components, action procedures, lubrication system, and other requirements specified in the equipment use.

3. When using the casting molding machine, it is necessary to carefully observe its operation. During operation, the lubricating and operating parts should be frequently blown clean with air to remove sand particles. It is strictly prohibited to stick sand to each lubricating part.

4. After completing each styling task, the workbench must be cleaned before the second styling task can begin.

5. After using the casting molding machine, the handle should be returned to the zero (empty) position, all valves should be closed, the equipment should be cleaned, and the site should be cleaned. The sliding (rotating) parts of the equipment should be kept clean and lubricated, and the tools and molds should be carefully inspected.